Logo Allmyblog
Logo Allmyblog
Lien de l'article    


Printer Toner Cartridge Supplies, Buy Toner Cartridges Online-V4ink
Contacter l'auteur de ce blog

- How does the printer ink reflow?
- The purchase and filling of the ink cartridges
- Several question when we filling the toner ink
- In the development of Ink cartridge made in China
- How to make the Cartridge ink insert the black ink?

<< Octobre >>

Ajouter adtozhou à vos favoris
 How does the printer ink reflow? Alerter l'administrateur Recommander à un ami Lien de l'article 

In the canon printer ink supply, there has been an annoying problem with printer ink reflow! It results too much resistance and can not continuous high-speed printing. For example, some office printers may not be used for a long time, the phenomenon of printer ink reflow is also found. Now, in the ink tube on the installation of one-way valve (long-term corrosion-resistant materials to do, no resistance type), then again do not worry about reflow problems. And the former modified machine can also be re-installed, simple, convenient and practical.

The main reason of printer ink reflow is that with the tight supply of the system caused by poor internal pressure imbalance, the main reasons are the following:

The first possibility is to reduce the position of the connection, even for the use or not in the state with the printer should be in the same level, which is all one of the cartridge even for the use of important considerations. Solution will be even with the printer on the same level, it is best to use double-sided adhesive will even sticke rs on the side of the printer, after the use of ink suction fixture.

The second may be in the modified cartridge in the reaming operation is too large or drilling or solid core plug is not completely plug in place caused by leakage. Solution: the solid plug plug in the re-plug in place, the more tight the better, and then use AB glue around the hollow plug to seal, after treatment with ink suction fixture.

The third may be the elbow was built into the cartridge inside the sponge blockage caused by the ink can not normally enter. Solution, pull out the elbow, with a toothpick will be the corresponding ink within the sponge thorn a few times, so that the sponge relaxation, but must control the depth of the piercing, to prevent the thorn to the nozzle. After treatment with ink suction fixture. (The third is too professional, not recommended)

If it is the second reason:

You can buy a sealed ring which is a little bit bigger than previous one, the general seller to provide are relatively small, then sealed with a sealant (hot melt).

  Aucun commentaire | Ecrire un nouveau commentaire Posté le 09-08-2017 à 09h02

 « Article précédant Retour à l'accueil du blog

 Articles dans la même catégorie
- The purchase and filling of the ink cartridges

- Several question when we filling the toner ink

- In the development of Ink cartridge made in China

- How to make the Cartridge ink insert the black ink?

 Liste des commentaires Ecrire un nouveau commentaire

 Ajouter un commentaire
:) ;) :o :D :s :( :@ :clown: :$ :star: +o( ^|
8( :] (6) (h) :p 9| :'( (y) (n) :| 8-| :{
:?: :nrv: (l) (u) :o/ :pig: :hand: (h5) :yin: :nuc: :x ;D
E-Mail (facultatif)
Blog (facultatif)
Se souvenir de mes informations
Recopier le code ci-contre :

Fil RSS 2.0
Ajouter à NetVibes
Ajouter à Google
Ajouter à Yahoo
Ajouter à Bloglines
Ajouter à Technorati

Allzic en direct

Liens Commerciaux
L'information à Lyon
Retrouvez toute l'actu lyonnaise 24/24h 7/7j !

L'information à Annecy
Retrouvez toute l'actu d'Annecy 24/24h 7/7j !

L'information à Grenoble
Retrouvez toute l'actu de Grenoble 24/24h 7/7j !

Application Restaurant
Restaurateurs, demandez un devis pour votre application iPhone

Fete des Lumières
Fête des lumières : vente de luminaires, lampes, ampoules, etc.

Votre publicité ici ?
  Blog créé le 09-08-2017 à 07h52 | Mis à jour le 09-08-2017 à 09h02 | Note : Pas de note